Filter
Top Products
• user id , which is the public user identification e.g. the phone
number xxxxx
• password, which is the password for the user id
4.1.1.1 CLI commands
The W25 has already one User Agent configured by default, so this needs
to be modified. The commands to modify are:
cf set ims.user_agent[0].auth_id <auth_id>
cf set ims.user_agent[0].user_id <user_id>
cf set ims.user_agent[0].user_password <password>
The command to save the new configuration is:
cf commit
To display the entries in the user account list, use the following command:
cf show ims.user_agent
ims.user_agent[0].auth_id "user.grp"
.user_id "54321"
.user_password "mysecret"
.ims_callserver_index 1
The last parameter “ims_callserver_index” is referring to the configuration
of IMS Call Server, which will be described below. Normally you do not
need to change this.
4.1.2 IMS Call Server
Here you configure the IMS/SIP server(s) address (IP or FQDN), and
possibly an outbound proxy.
The SIP-server address configuration is mandatory while the outbound
proxy is optional, depending on network configuration.
The outbound proxy is usually an SBC (Session Border Controller) e.g. IMS
P-CFCS
4.1.2.1 CLI commands
The W25 has already one IMS Call Server defined with default values, but
the SIP proxy and outbound proxy addresses (IP or FQDN) need to be
modified. The commands for this are:
cf set ims.callserver.proxy[0].address <sip proxy>
cf set ims.callserver.outbound_proxy <outbound proxy>
The command to save the new configuration is:
cf commit
2/221 02-FGB 101 327 Uen B – November 2007 11