Filter
Top Products
- Eng 15 -
English
Español
Português
Français Pyсский
한국어
- Eng 16 -
한국어
Pyсский Français
Português
Español
English
■ Measurement in a reclining posture
1 Lie down, facing the celling.
2 Lightly open your hand with palm up and straighten your arm.
3 Relax your body, arm and fi ngers.
4 Do not move your body or talk during measurement.
* Relax yourself to avoid placing
pressure on the cuff.
■ You may use your right arm to measure your blood pressure.
Blood pressure value is likely to differ by as much as 10 mmHg when measured on
the right arm instead of the left (or vice-versa). Measure your blood pressure on the
same arm each day.
TIPS FOR OBTAINING ACCURATE MEASUREMENTS
Your blood pressure varies according to your posture, the time of day and a range of
other factors. Ideally, you should measure your blood pressure in the same posture
at the same time every day.
■ Taking measurements while sitting
1 Place your arm on a table or similar
surface with your forearm extended.
2 It is important to have the cuff level with
your heart.
3 Open your hand slightly on the table
so that your palm is facing up and your
fi ngers are relaxed.
4 Do not move your body or talk while
taking the measurement.
AUTOMATIC POWER OFF FEATURE
• After taking the blood pressure measurement, pressing the “START/STOP” switch
will turn the monitor off. However, if you do not press the switch, the monitor’s
Auto OFF function will automatically turn the monitor off after 3 minutes.
90 measurement results can be stored in
Memory.
The average value is calculated
automatically to help you manage your daily
health.
mmHg mmHg
mmHg mmHg
2 If you press the Memory switch again, past measurement data are
displayed.
Each time you press the switch, the measurement data are displayed in order from the
most recent to the oldest.
* You can fast-forward the data numbers in display by pressing and holding the
Memory switch.
* Example of display when the
Memory switch is pressed.
mmHg mmHg
mmHg mmHg
CALLING UP THE DATA STORED IN MEMORY
Memory switch
The data number is
displayed before the
measurement results.
1 Press the Memory switch once.
* Example of display when the
Memory switch is pressed.
indicating the average value appears at the bottom of the display. Then
the average value, based on the last three measurements, is displayed.
* (
and the average value do not appear if there are two or fewer
measurements stored in memory.)