Filter
Top Products
- Eng 18 -
Deutsch
English
Español Português Italiano
Français
- Eng 19 -
English
EspañolPortuguêsDeutsch
Français
Italiano
CALLING UP THE DATA STORED IN MEMORY
HOW TO CALL UP THE DATA
• “3A” and the average value appear on
the display. (“3A” and the average value
do not appear if there are two or fewer
measurements stored in memory.)
“3A” and pulse are alternately displayed.
• 90 measurement results can be stored in the
memory.
• Except for the case where the unit is engaged
in measurement, press “MEMORY” switch to
call up the values (measurement results) stored
in memory to the display.
* To erase all the data, remove the batteries. All
the stored data is erased.
• Press the “MEMORY” switch.
• Press the “MEMORY” switch again. The
memory number “1” and the last set of data
stored appear on the display. (The memory
number and pulse are alternately displayed.)
• Press the “MEMORY” switch again. The
memory number “2” and the second last set
of data stored appear on the display.
Each time you press this switch, the unit
displays the data prior to the last set of data
displayed.
• The value stored in memory is numbered in
the order of measurements. For example,
when 90 sets of data are stored in memory,
the data number 1 represents the latest data.
Data number: 1, 2, 3, ... ... 89, 90
©
The latest
data
©
The earliest
data
* You can fast-forward the data numbers
in display by pressing and holding the
“MEMORY” switch.
CALLING UP THE DATA STORED IN MEMORY