Filter
Top Products
- Eng 20 -
In this mode, the pressure in the cuff is raised to the correct level automatically,
according to the previous measurement stored in memory, and your blood
pressure is measured.
1
Press .
The cuff is inflated immediately after the mark is
turned on and then off.
The starting pressure is set automatically, based
on the last measurement taken, which is stored in
memory.
• The first time you use the blood pressure monitor
after replacing the battery, the pressure will be set to
160mmHg.
• If the level of the pressure is not enough, the
pressure is automatically heightened to the level for
measurement of the blood pressure again.
* If the pressure is still too low, "Err1" will appear and
the measurement will be cancelled. If this happens,
use the Manual Pressurizing mode to measure your
blood pressure. Then, the blood pressure reading
will be stored and you will be able to measure
your blood pressure easily the next time, using the
Automatic Pressurizing mode.
A little while after the starting pressure reaches
the correct level, the
mark will be lit and the
measurement will start automatically.
UAutomatic Pressurizing mode
HOW TO MEASURE YOU BLOOD PRESSURE