Filter
Top Products
You can select desired work clamp lowering operation from three patterns by
changing memory switch settings.
3 types of work clamp lowering operation
(BAS-311G Motor-driven work clamp spec.)
Simple adjustment
The driver phase can be adjusted from the side without tilting the
sewing machine. This reduces time taken for the adjustment
and improves productivity when materials are changed.
Driver phase can be adjusted easily
Pulley positioned in convenient location
The pulley is positioned in the
convenient location on the
side of the sewing machine
arm. Needle drop and hook
timing can be checked easily.
Options
Needle cooler*
(SA5559101)
Thread wiper set*
(Pneumatic type)
(SA5575101)
Inner clamping device
(100 x 60)(SA7189101)
Thread breakage detector
(SA5193101)
Triple pedal foot switch
(SA6495101)
Sewing data
programming software
PS-300B
* This device requires the optional
solenoid valve set.
The work clamp is lowered from the highest position to pause at an
intermediate position, then lowered to the lowest position. Quick and
accurate positioning of materials can be made with an optimal work clamp
height. The total cycle time can be reduced.
Two-step lowering*:
The work clamp is lowered from the highest position to the lowest position
at once. The quick pressing operation is suitable for occasions when
positioning materials with the work clamp is not necessary while it is
positioned with the feed plate beforehand.
One-step lowering:
Analog lowering:
* The factory setting is two-step lowering.
The work clamp is lowered in
direct proportion to the pedal
depression amount without
steps. You can lower it with
making subtle positioning of
materials.