Filter
Top Products
12
Using the special cord set, connect the shaver to an
electrical outlet with the motor switched off.
When charging for the first time or when the appliance is
not used for a few months, leave the appliance to charge
continuously for 4 hours.
The charging light (5) shows that the appliance is being
charged. When the battery is fully charged, the charging
light turns off. Intermittent blinking after a while indicates
that the battery maintains its full capacity. This can also
happen short term when charging after the battery was
completely discharged.
A full charge provides 30 minutes of cordless shaving time
depending on your beard growth.
Once the shaver is completely charged, discharge the
shaver through normal use. Then recharge to full capacity.
Subsequent charges will take about 1 hour.
Maximum battery capacity will only be reached after
several charging/discharging cycles.
5-minute quick charge is sufficient for a shave.
Shaving
First, remove the trimming attachment (7): Using your
thumbs, press against the side clips of the trimming
attachment so that they swing off in the direction of the
arrows (a). Activate the on/off switch (6). The floating foil
frame automatically adapts to your skin surface for a close,
smooth shave.
For best results:
Always shave before washing your face.
At all times, hold the shaver at right angles (90°) to the
skin (b).
Stretch the skin and shave against the direction of beard
growth.
For pre-shaving after a few days of not having shaved, use
the wide shaper (4a) to pre-cut long hairs. For a close,
smooth shave, finish with the foil.
To maintain 100% shaving performance, replace your foil
and cutter block at least every 18 months or when worn.
This appliance is suitable for use in a bath or shower.
When using it in the shower, we recommend
applying shaving foam or gel.
•
•
•
•
•
•
•
•
•
•
•
•
99507069_Cruzer4_Z60_China 1299507069_Cruzer4_Z60_China 12 26.03.2010 13:34:14 Uhr26.03.2010 13:34:14 Uhr