Filter
Top Products
13
Keeping your shaver in top shape
Automated cleaning
The Braun Clean&Charge takes care of all cleaning and
lubrication needs of your shaver. Please refer to the
separate use instructions.
If not supplied already with your shaver, the Braun
Clean&Charge is available at your dealer or Braun Service
Centres.
Manual cleaning
For easy cleaning after each shave, switch the shaver
off. Press the release buttons to lift the shaver foil
(do not remove the foil completely). Switch on
the
shaver for approx. 5-10 seconds so that the shaved
stubbles can fall out.
For a thorough cleaning (weekly), remove the shaver
foil and tap it out on a flat surface. Using the brush,
clean the cutter block and the inner area of the pivoting
head. About every four weeks, clean the cutter block
with Braun cleaning agents.
If your skin is very dry and you notice a reduced
operation time of the shaver or if the display shows «oil!»,
apply a drop of light machine oil onto the shaver foil.
Replacing the shaving parts
The shaver foil and cutter block are precision parts that,
in time, are subject to wear. Replace your foil and cutter
block every 18 months and get a 25% better shave.*
(Shaver foil and cutter block: part No. 7000. Available at
your dealer or Braun Service Centres.)
(* Overall evaluation from Braun users comparing their
shave with new parts and those used for 18 months.)
Tips for the perfect shave
•
We recommend that you shave before washing,
as the skin tends to be slightly swollen after washing.
•
Hold the shaver at right angles (90°) to the skin.
•
Stretch your skin and shave against the direction
of beard growth.
•
Replace the shaver foil and cutter block every
1
1
/
2
years, or when the parts are worn, to ensure
optimum shaving performance.
oil
10
10
7000
7000
Syncro
5491384_S 4-82 Seite 13 Mittwoch, 18. September 2002 9:00 09