Filter
Top Products
11
•
Do not expose the shaver to temperatures of more than
50 °C for longer periods of time.
Display
The pilot light shows that the shaver is connected to the
mains.
The display shows the operation mode and charging
conditions of the shaver: During charging the display
shows the battery capacity symbol increasing by 20%
segments and the remaining charging time (flashing):
First charging (4 h):
The display counts down in 20 min. steps.
Subsequent chargings (1 h):
The display counts down in 5 min. steps.
The battery is fully charged. SmartLogic inside monitors
the battery and communicates when it is still well charged.
Below 10 minutes remaining shaving time, the display
shows the minutes left. The «moving» plug symbol
indicates that you should charge your shaver. If there is
insufficient battery charge for a cordless shave, either
recharge the shaver or shave via the power supply cord
connected to the mains.
The display changes to this format when the shaver is in
the Clean&Charge.
The SmartLogic inside your shaver automatically monitors
the condition of the batteries as well as the charging/dis-
charging processes and adapts them to your personal
shaving patterns. For instance, if it is your routine to never
let the batteries run low, the SmartLogic will recognize this,
look for a pause when you are likely to not use the shaver
and completely discharge and then recharge your shaver
to recondition the batteries (every six months at the most,
and only when necessary).
For additional information, press the info key:
press once:
– to display the duration of the last shave
7680
7680
*
*
5491384_S 4-82 Seite 11 Mittwoch, 18. September 2002 9:00 09