Filter
Top Products
33
Clean & Charge
Braun Clean&Charge has been developed
for cleaning, charging and storing your
shaver. Clean your shaver daily in the
Clean&Charge.
During the automated cleaning process,
the shaver is switched on and off at intervals
to obtain best cleaning results. Since the
specially formulated cleaning fluid contains
a small amount of oil, the cleaning procedure
also fulfills the lubrication needs of the
shaver.
Important
•
Only use the power supply cord set supplied
with the shaver.
•
In order to avoid any leakage of the cleaning
fluid, place the appliance on a flat, stable
surface. Do not tip, move suddenly
or transport in any way if a cleaning cartridge
is installed.
•
Do not place the appliance in a mirror cabi-
net, nor store it over radiators, nor place it
on polished or laquered surfaces. Do not
expose to direct sunlight.
•
The appliance contains highly
flammable liquid. Keep it away from
sources of ignition. No smoking.
Keep out of reach of children. Do not refill
cartridge. Use only original Braun refill
cartridge.
•
When cleaning the shaver, its protection
cap should be removed.
Description
1 Lift button for cartridge exchange
2 Contact bow
3 Start/release button
4 Level indicator
5 Cleaning cartridge
Before using Clean&Charge
Installing the cartridge
•
Press the lift button (1) to open the housing.
•
Hold the cartridge down on a flat, stable
surface (e.g. table). Carefully remove the lid
from the cartridge. Slide the cartridge into
the base as far as it will go.
•
Slowly close the housing by pushing it down
until it locks.
Replacing the cartridge
After having pressed the lift button to open
the housing, wait for a few seconds before
removing the used cartridge.
Before discarding the used cartridge, make
sure to close the openings using the lid of
the new
cartridge, since the used cartridge
will contain contaminated cleaning solution.
The used cartridge can be disposed in the
household waste.
Operating your Clean&Charge
•
Connect your Clean&Charge with the cord
set to the mains electricity supply. The
special socket at the back is adjustable to
save space. After each shave, switch the
shaver off and put it into the Clean&Charge,
upside down and with the front showing.
•
Push the start/release button (3) to lock and
connect the shaver. The cleaning process
will start. The yellow light on the shaver will
flash during the complete process (approx. 5
minutes cleaning, 4 hours drying).
•
Do not interrupt the cleaning process, as it
leaves the shaver wet and not fit for use. If
interruption is needed nonetheless, press
the start/release button button (3).
•
When cleaning is finished, the yellow light
will go off and the shaver is ready for use. To
release it, push the start/release button.
FlexXP_5795/90_Japan Seite 33 Donnerstag, 12. Dezember 2002 10:27 10