Filter
Top Products
30
Shaver
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
shaver.
Warning
Your shaver is provided with a low voltage
adapter. Therefore you must not exchange or
manipulate any part of it. Otherwise there is
risk of electric shock
Description
1 Shaver foil
2 Cutter block
3 Release button
4 On/off switch
5 Long hair trimmer
6 Charging light (green)
7 Cleaning light (yellow)
8
Special power supply cord set
Charging the shaver
• When charging for the first time: Using the
power supply cord set, charge the shaver
directly off the mains for at least 8 hours
(shaver and adapter might get warm).
• Once the shaver is completely charged,
shave without cord. With normal use the
shaver will be charged automatically after
every cleaning in the Clean&Charge (see
separate instructions).
• The green charging light indicates that the
shaver is being charged.
• A full charge will give up to 40 minutes of
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for
charging is 15°C to 35°C.
• When fully discharged, you may also shave
with the shaver connected to the mains via
the power supply cord set.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Keeping your shaver in top
shape
Cleaning indicator
Your shaver should be cleaned daily in the
Clean&Charge, and certainly when the yellow
cleaning light shines constantly after shaving.
If this is not done, the yellow light will go out
after some time. The shaver‘s electronics will
then assume it has been cleaned manually
and a new calculation of the the time when the
next cleaning is required will be started.
During the cleaning process in the
Clean&Charge the yellow light will flash and
go off after approx. 4 hours when cleaning is
finished.
Automatic cleaning
Once the shaver is put into in the
Clean&Charge, it is cleaned automatically (see
separate instructions). Manual cleaning is
recommended only when the Clean&Charge
is not available, e.g. when travelling.
Tips for the perfect shave
• We recommend that you shave before
washing, as the skin tends to be slightly
swollen after washing.
• Hold the shaver at right angles (90°) to the
skin. Stretch your skin and shave against
the direction of beard growth.
• To ensure optimum shaving per-
formance, we recommend to replace the
shaver foil and cutter block every 18
months, or when the parts are worn.
English
FlexXP_5795/90_Japan Seite 30 Donnerstag, 12. Dezember 2002 10:27 10