Filter
Top Products
10
substances. Rinse off all foam and let the shaver run for a
few more seconds.
• Next, switch off the shaver, remove the shaver foil and the
cutter block. Then leave the disassembled shaving parts to
dry.
•
Put a drop of light machine oil onto the shapers (4a, 4b)
and the shaver foil (h).
Alternatively, you may clean the shaver using the brush
provided (g):
• Switch off the shaver. Remove the shaver foil.
• Using the brush, clean the cutter block and the inner
area of the shaver head. However, do not clean the
shaver foil with the brush as this may damage the foil.
Replacing the shaving parts
To maintain 100% shaving performance, replace your foil
and cutter block at least every 18 months or when worn.
Change both parts at the same time for a closer shave with
less skin irritation.
(Shaver foil and cutter block: 2000 Series)
Preserving the batteries
In order to maintain the optimum capacity of the recharge-
able batteries, the shaver has to be fully discharged (by
shaving) approximately every 6 months. Then recharge the
shaver to full capacity. Do not expose the shaver to tem-
peratures higher than 122°F/50°C for extended periods of
time.
Environmental notice
This appliance is provided with nickel-hydride
rechargeable batteries. They do not contain any
harmful heavy metals. Nevertheless, in the interest
of recycling raw materials, please do not dispose
of this appliance in the household waste at the end
of its useful life. Disposal can take place at a Braun Service
Center or appropriate collection sites.
Subject to change without notice.
For electric specifications see printing on the special cord
set.
Cruzer_2865_NA Seite 10 Dienstag, 8. November 2005 12:07 12