Filter
Top Products
8
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Styler
4a Wide shaper (1.1 in / 28 mm)
4b Narrow shaper (0.55 in / 14 mm)
5 Charging light
6 On/off switch (run)
7 Trimming attachment
8 Beard length setting
9 Special cord set
Charging
The best environmental temperature for charging is between
60°F and 95°F (15°C and 35°C).
• Using the special cord set, connect the shaver to an
electrical outlet with the motor switched off.
• When charging for the first time, leave the shaver to
charge continuously for 4 hours. Subsequent charges
will take about 1 hour.
• The charging light (5) shows that the shaver is being
charged. When the battery is fully charged, the charging
light intermittently blinks on and off. This indicates that
the battery maintains its full capacity.
• Once the shaver is completely charged, discharge the
shaver through normal use before recharging again to
full capacity.
• A full charge provides 30 minutes of cordless shaving
time depending on your beard growth. However, the
maximum battery capacity will only be reached after
several charging/discharging cycles.
• If the rechargeable batteries are discharged, you may
also shave by connecting the shaver to an electrical
outlet via the special cord set.
Shaving
First, remove the trimming attachment (a): Using your
thumbs, press against the side clips of the trimming
attachment so that they swing off in the direction of the
arrows.
Activate the on/off switch (6). The floating foil frame
automatically adjusts to the contours of your face for a
close, smooth shave.
For pre-shaving after a few days of not having shaved, use
the wide shaper (4a) to pre-cut long hairs. For a close,
smooth shave, finish with the foil.
Cruzer_2865_NA Seite 8 Dienstag, 8. November 2005 12:07 12