Filter
Top Products
10
For pre-shaving after a few days of not having shaved, use
the wide shaper (4a) to pre-cut long hairs. For a close,
smooth shave, finish with the foil.
This appliance may also be used in the shower. Before doing
so, make sure that it is unplugged!
When using it in the shower, we recommend applying
shaving foam or gel.
Using the styler
• The wide shaper (4a) evenly cuts and trims larger areas
(c): Ideal for shaping sideburns, moustaches and partial
short beards. Press the blue rib to push out the styler (4).
• The narrow shaper (4b) precisely defines lines and
edges (d): Ideal for precise contouring. To use the
narrow shaper, push out the styler and turn it 180°.
• Frequent use of the styler may reduce the battery
capacity.
Using the trimming attachment
• The trimming attachment (7) is ideal for beard trimming
and keeping it at a constant length.
• Place the trimming attachment onto the shaver foil (2)
and press it against the shaver housing until it snaps into
place with a click.
• Press the beard length selector (8) (e) and slide it up in
order to set the desired beard length (length settings
from top to bottom 1.2 mm, 2.8 mm, 4.4 mm, 6 mm).
Push out the styler (4).
• Activate the on/off switch and trim against hair growth
by guiding the blue transparent comb part over the skin.
• After use, pull back the styler. Remove the trimming
attachment (a).
Cleaning
Always unplug the appliance before cleaning.
Regular cleaning ensures better shaving performance.
Rinsing the shaving head after each shave under running
water is an easy and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse the shaving
head under hot running water (f). A natural based soap
may also be used provided it contains no particles or
Tips for the perfect shave
• We recommend that you shave before washing, as
the skin tends to be slightly swollen after washing.
• Hold the shaver at right angles (90°) to the skin (b).
Stretch the skin and shave against the direction of
beard growth.
• To maintain 100% shaving performance, replace your
foil and cutter block at least every 18 months or when
worn.
Cruzer_2865_MN Seite 10 Montag, 17. Mai 2004 3:03 15