Filter
Top Products
11
abrasive substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, remove the shaver foil and
the cutter block. Then leave the disassembled shaving
parts to dry.
Alternatively, you may clean the shaver using the brush
provided (g):
• Switch off the shaver. Remove the shaver foil.
• Using the brush, clean the cutter block and the inner
area of the shaver head. However, do not clean the
shaver foil with the brush as this may damage the foil.
Keeping your shaver in top shape
About every four weeks, clean the cutter block with Braun
cleaning agents. Put a drop of light machine oil onto the
shapers (4a, 4b) and the shaver foil (h).
Replacing the shaving parts
To maintain 100% shaving performance, replace your foil
and cutter block at least every 18 months or when worn.
Change both parts at the same time for a closer shave with
less skin irritation.
(Shaver foil and cutter block: 2000 series)
Preserving the batteries
In order to maintain the optimum capacity of the recharge-
able batteries, the shaver has to be fully discharged (by
shaving) every 6 months approximately. Then recharge
the shaver to full capacity. Do not expose the shaver to
temperatures higher than 50 °C for extended periods of
time.
Environmental notice
This appliance is provided with nickel-hydride rechargeable
batteries. To protect the environment, do not dispose of this
appliance in the household waste at the end of its useful life.
Open the housing as shown on page 46, remove and
dispose of the batteries at your retail store or at appropriate
collection sites according to national or local regulations.
Subject to change without notice.
This product conforms to the EMC-Directive
89/336/EEC and to the Low Voltage Regulation
(73/23 EEC).
Electric specifications see printing on the special cord set.
Cruzer_2865_MN Seite 11 Montag, 17. Mai 2004 3:03 15