Black & Decker PX1200 Hair Dryer User Manual


 
English
-4-
After use
Switch off and remove the plug from the
socket before leaving the appliance
unattended and before changing,
cleaning or inspecting any parts of the
appliance.
When not in use, the appliance should
be stored in a dry place. Children should
not have access to stored appliances.
Inspection and repairs
Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may affect
its operation.
Do not use the appliance if any part is
damaged or defective.
Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
Before use, check the power supply cord
for signs of damage, ageing and wear.
Do not use the appliance if the power
supply cord or mains plug is damaged or
defective.
If the power supply cord or mains plug is
damaged or defective it must be
repaired by an authorised repair agent in
order to avoid a hazard. Do not cut the
power supply cord and do not attempt
to repair it yourself.
Never attempt to remove or replace any
parts other than those specified in this
manual.
Warning symbols
The following symbols are used on the
product or in the manual.
Do not use this appliance near
bathtubs, showers, basins or other
vessels containing water.
When the hairdryer is used in a bathroom,
unplug it after use since the proximity of
water presents a hazard even when the hair
dryer is switched off.
Denotes risk of personal injury or
damage to the product in case of
nonobservance of the instructions in
this manual.
Denotes risk of electric shock.
Electrical safety
This tool is double insulated in
accordance with EN 60335;
therefore no earth wire is required. Always
check that the power supply corresponds to
the voltage on the rating plate.
To avoid the risk of electric shock,
do not immerse the cord, plug or
motor unit in water or other liquid.
For additional protection, the installation of
a Residual Current Device (RCD) having a
rated residual operating current not
exceeding 30mA is advisable in the
electrical circuit supplying the bathroom.
Ask your installer for advice.
Features
1 On / Off switch
2 Voltage selector
3 Hanging loop
4 Concentrator nozzle