Filter
Top Products
5. Turn vehicle accessories off.
6. A solid green LED indicates a good alternator. A solid red LED indicates a bad alternator.
USING THE 12 VOLT DC PORTABLE POWER SUPPLY
1. Flip open one of the 12 volt DC outlet covers on the DC Power Supply Panel.
2. Insert the 12 volt DC plug from the appliance into the outlet.
3. Turn on the appliance and operate normally.
NOTE: The 12 volt DC accessory outlets on the unit are protected by a 5 Amp manual
resetting breaker that will trip in the event of overload. Simply unplug the appliance to reset
the breaker. To avoid tripping this breaker, DO NOT USE UNIT TO POWER APPLIANCES
THAT DRAW MORE THAN 5 AMPS DC.
USING THE 120 VOLT AC POWER SUPPLY
The 120 Volt AC Power Supply is designed for maintaining today's modern lifestyle while
traveling in vans, RVs, automobiles, trucks, or vehicles that have a 12 volt DC battery
power supply and a means to recharge those batteries. The Electromate
®
400 Plus comes with:
1. AC On/Off Switch — to turn the AC Power Supply on and off.
2. 120 Volt AC Power Outlets
3. AC Power Supply “ON” Status Indicator — green LED lights when AC outlet is turned
on; green LED flashes on and off when faulted.
4. AC Power Ground Fault Circuit Interrupt (GFCI) — a 3-prong outlet for 120 volt AC
appliances which shuts down inverter if leakage or ground fault current is detected.
5. Internal protective circuits including:
• Overload and over-temperature shutdown (activated if AC output exceeds 400 watts)
• AC short-circuit shutdown
• Low voltage shutdown
• A new cooling technology that more efficiently cools the power transistors and,
combined with soft start, dramatically increases reliability and product life
10
AIR VENTS
12 VOLT DC OUTLETS
DC Power Supply Panel
PS400JRB_Manual EN_090506 SE.qxp 9/6/06 3:38 PM Page 10