Black & Decker HD200 Hair Dryer User Manual


 
4
Additional Information
User Maintenance
For dual-voltage dryers (Model HD300):
For use in 120V countries, the Dual Voltage
Selector should be placed in the 120V
position. For use in several countries
overseas, you may need to place the volt-
age selector in the 230V position. Confirm
the voltage available at each overseas
location before using the appliance.
For 100-120 Volt Operation - Using a coin
or screwdriver, turn the Dual Voltage
Selector to the 120V position (A). In this
position, the dryer operates in all available
heat and speed settings.
For 220-250 Volt
Operation - Use a
coin or screwdriver to
turn the Dual Voltage
Selector to the 230V
position. Do not
attempt to change to
120V when operating
on 230V. A plug adapter may be neces-
sary in certain countries.
A
For proper operating performance, the
dryer must be kept clean. Blocked or
clogged air intake vents will cause the
dryer to overheat. If overheating occurs,
an automatic safety device will shut the
dryer or heat off to prevent damage or
personal injury. If the unit or the heat
cycles off, unplug the cord and allow the
dryer to cool for 10 to 15 minutes before
restarting. Be sure air vents are clean.
When cleaning is needed, unplug, and
clean dust and lint from air intake open-
ings with a small brush. The outer sur-
face of the dryer should be wiped clean
with a damp cloth only.
For models with a removable filter
(HD400) –
unscrew
cap,
remove
the filter,
brush lint
free.
Replace
filter and
cap. (B)
Caution - NEVER allow the power supply
cord to be pulled, twisted, or severely
bent. Never wrap the cord tightly
around the dryer. Damage will occur at
the high flex point of entry into the dryer,
causing it to rupture and short. Inspect
the cord frequently for damage. Stop
use immediately if damage is visible or
unit stops or operates intermittently. If
the cord or dryer is damaged or does not
operate properly, return it to an autho-
rized service center for repair. Do not
attempted to repair the unit.
Storage - When not in use, your dryer
should be disconnected and stored in a
safe, dry location, out of reach of chil-
dren. Do not wrap line cord around
dryer. Allow the cord to hang or lie
loose and straight at the point of entry
into the dryer. For easy storage, hang
the unit from its built-in storage loop.
B