Filter
Top Products
Location and Functions of Control
2-1
5975847 BARCOGRAPHICS 1208S 220197
2
LOCATION AND FUNCTION OF CONTROLS
REAR PANEL TERMINOLOGY
Communication Port (800 peripherals)
* allows communication between the RCVDS switcher and
the projector.
* allows connection of a remote IR receiver unit to the
projector.
Port 3
RGB Analog Input (9 pin female sub D connector). Allows
a character generator, microcomputer, etc. having analog
RGB outputs to be connected to the projector.
Port 4/5 : RGB-S Input (5x BNC connector):
RGB-S input : allows a character generator, microcom-
puter, video camera, etc. having analog RGB output to be
connected to the projector.
Line inputs: - signals RED-GREEN-BLUE
- COMPOSITE sync. signal
- Tri level sync signal (option)
VIDEO Input (Composite video, 2x loop-through BNC
connector)
: allows a video tape recorder, video camera,
color receiver/monitor, etc. having video line output to be
connected to the projector.
75 ohm Termination Switch for Video signals
1
Projector Pilot Lamp : indicates the status of the projector.
- unlit : mains (power) switch is not pressed.
- lit : mains (power) switch is pressed and the indicated color
shows the projector mode:
Green color : operational mode of the projector.
Red color : standby mode of the projector.
Important : projector ("Operational" or "Standby") mode is
defined during the installation of the projector. (Refer to a
qualified technician for change).
S-VIDEO Input: Separated Y/C (luma-chroma) signal in-
puts and outputs for higher quality playback of Super VHS
signals (4-pin S-VIDEO connector loop-through).
75 ohm Termination Switch for S-Video signals
Power Switch :
press the switch to turn the projector ON.
Depending on the hardware set-up of the projector during
installation, the projector switches to
‘Standby’ or to ‘Op-
erational'
mode. If in standby, the standby LED lights up.
FRONT PANEL TERMINOLOGY
RS 232 Input Port
Connection between the projector and an IBM PC (or
compatible) or MAC (RS422) for remote computer control
and data communication.
RS 232 Output Port
RS 232 Input Port allows a communication link for PC or
MAC to the next projector in a series of projector.
IR Sensor
receiver for control signals transmitted from the RCU.
IR Remote
Connector for remote input for hard wired remote control
Power (mains) input
Connect the supplied ac power (mains) cord here and to
the wall outlet.
75 ohm
OFF ON
PORT 1
(VIDEO)
PORT 4/5
(RGB - HV)
Comp/H sync V sync
RGB
PORT 6
REMO TE
COMMUNICATION
PROJECTOR MODE POWER/MAINS
PORT 2
(S-VIDEO)
75 ohm
ONOFF
GREEN : operational
RED : stand-by
1
23
4
5
6
7
PORT 3
2
3
4
5
6
7
1
2
3
4
4
RS232 OUT
RS232 IN
IR
REMOTE
1
2 3
4
REMOTE
IR
RS232 OUT
RS232 IN
V NOM
I MAX
FREQ
120/230 Volt
7/5Amp
50/60Hz
5
685