Filter
Top Products
19510317700 English, All Logos to be Ariston {PDF Created 18/01/13 22:04:00}
4
! Ensure that the dryer is adequately ventilated and
that the end of the vent tube is not directed towards
the air intake duct.
! The vent tube must always be fitted for optimum
performance.
! Make sure that the vent tube and air intake vents
are not obstructed or blocked.
! The dryer must not recycle exhaust air.
! Misusing a tumble dryer may create a fire hazard.
! Do not discharge exhaust air into a flue which is
used for exhaust fumes from other appliances that
burn gas or other fuels.
! Do not discharge the exhaust air into an extraction
system or any duct with an extractor fan. This will
affect the way the thermal controls operate and can
result in a fire hazard.
Electrical connection
Make sure of the following before you insert the plug
into the electrical socket:
• The socket must be grounded.
• The socket must be able to sustain the machine’s
maximum power, which is indicated on the rating
label (see Dryer Description).
• Power voltage must be within the values indicated
on the rating label (see Dryer Description).
• The socket must be compatible with the dryer’s
plug. Should this not be the case, replace the plug
or the socket.
! The dryer must not be installed outdoors, even if the
space is sheltered. It can be very dangerous if
exposed to rain or storms.
! Once installed, the dryer’s electrical wire and plug
must be within reach.
TD4002AUS Issue 2
! Do not use extension cords
! The power cord must not be bent or squashed.
! The power cord should be checked periodically and
replaced by a cord specially prepared for this dryer
and fitted only by authorised technicians. (see
Service). New or longer power cords are supplied at
an extra charge by authorised dealers.
! Ensure that any portable outlet or extension lead is
positioned so that it is not subjected to any splashing or
ingress of moistures
! The manufacturer denies any responsibility should
any of these rules not be followed.
! If in doubt about any of the above consult a
qualified electrician
Levelling your dryer
The dryer must be installed level for correct operation.
When you have installed your dryer in its final location
check that it is level first side-to-side, then front to
back.
If the dryer is not level, use a wooden block to
support it while adjusting the two front legs up or
down until your dryer is level.
Before you start using your dryer
Once you’ve installed your dryer and before you use
it, clean the inside of the drum to remove any dust that
could have accumulated during transportation.
GB
Open window venting
The end of the tube
should be directed
downwards to prevent
warm and moist air from
condensing in the room
or in the dryer.