Filter
Top Products
6. LOOP - This button will set a 4 beat loop and activate loop divide and multiply functions on the
FX select knob.
7. PLAY/PAUSE BUTTON - Press this button to PLAY/PAUSE what ever music source is playing.
8. CUE - Pressing the CUE button during playback immediately pauses playback and returns the
track to the last set cue point. The red CUE LED will glow when the unit is in cue mode. The LED will
also flash every time a new CUE POINT is set. The CUE button can be held down to momentarily
play the track. When you release the CUE button it instantly returns to the CUE POINT. You can also
tap the CUE button to create a BOP EFFECT.
9. SYNC BUTTON - Use this button to set this deck to master and auto sync and the other deck's
tempo to master.
10. VINYL BUTTON - Pushing this button activates SCRATCH mode.
11. CROSSFADER - This fader is used to blend the output signals of channels A and B together.
When the fader is in the full left position (channel A), the output signal of channel A will be controlled
by the master volume level. The same fundamentals will apply for channel B. Sliding the fader from
one position to another will vary the output signals of channels A and B respectively. When the cross-
fader is set in the center position, the output signals of both the channels A and channels B will be
even.
12. JOG WHEEL - This wheel has three functions;
Attention: Make sure that NOTHING is touch or resting on the jog wheels when you power on the
ELMC-1.
A. The wheel works as a pitch bend during Playback. Turning the wheel clockwise can increase the
pitch percentage up to 100%, and turning the wheel in the counter-clockwise direction can de-
crease the pitch percentage down to -100%. The pitch bend will be determined on how long
you turn the jog wheel continuously.
B. The jog wheel also controls the scratch effect, when the scratch effect is active.
C. The jog wheel can also serve as frame search. To use frame search the track must be paused
and the scratch effect must be disabled.
Note: The inside of the wheel is touch sensitive and the outside edge of the wheel is not. Example:
You can scratch by touching the inside or center of the wheel, and pitch bend when you touch the
outside edge of the wheel.
GENERAL FUNCTIONS AND CONTROLS (Cont.)
©American Audio® - www.americanaudio.us - ELMC-1 Instruction Manual Page 10
REAR PANEL - GENERAL FUNCTIONS AND CONTROLS
REAR PANEL -
13. USB PORT - Connect to your PC for MIDI interface.
13