Filter
Top Products
Operation
How to obtain the proper weight for a letter or package:
1. Before weighing an item, make sure the scale shows a zero weight indication. If it does not,
remove all items from the platter and press the ON/ZERO key.
2. Place the item on the center of the scale’s platter and allow the weight indication to stabilize.
3. Select the desired class of mail by pressing the MODE key.
4. After selecting the desired mail class the correct postage amount will be displayed.
● Auto Shutdown – The scale will automatically turn off after approximately two minutes.
Counting/Sample operation:
1. At any time, press the SAMPLE key. The scale displays the message “10 0”. This is the sample
size.
2. Add ten identical pieces. The scale shows “10-“.
3. Press the SAMPLE key again. If the items are heavy enough, the scale is in pieces mode and
displays ten pieces with no annunciator. If there is a sampling error, the scale briefly shows “Add”
then updates the sample size first to 25 pieces then to 50 pieces. If the operation fails for 50
pieces, then the parts are too light for the scale to process at all.
Message Explanation
“o o o o”
Indicates that the weighing capacity of the scale has been
exceeded.
bAtt Indicates that the batteries need to be replaced.
Add
Indicates that there is not enough internal resolution to
calculate the unit weight of an item. This means that the
items you are counting are too light for the scale to process
at all.
Lo
Indicates that the unit weight of the items you are sampling
is too light for the scale to process accurately.
O L
Indicates that the item on the scale exceeds the weight for
the class of mail.
U L
Indicates that the item on the scale is too light for the class
of mail.
Err 2
The scale’s calibration information has been lost.
Recalibrate scale.
“- - - -“
Indicates that the weight on the scale is negative. Press
the ON/ZERO key.
Possible Scale Operation Error Messages