Filter
Top Products
8
Press
Press and hold
Press and hold
12-hour
cloc
k
24-hour
cloc
k
Using the Monitor
Notes on the Built-in Clock
The monitor displays the clock as long as power is connected.
Adjust the clock prior to use.
The current clock setting will be cleared if the batteries are removed, or
power is not connected for approximately 30 seconds while the AC
adapter is used. In this case, adjust the clock again.
When adjusting the clock, press the
button to increase the value by
one, or press and hold the
button to change the value continuously.
The setting procedure cannot be reversed. If the wrong value is set, start
the setting procedure again.
After 30 seconds of non-operation, the setting procedure will be
automatically canceled.
To cancel the operation anytime, press the START button.
During measurement, the clock adjustment is not available.
Selecting the Clock Mode
Two clock modes are available, 12-hour clock or 24-hour clock.
1. Press and hold the
button
until the year starts blinking.
2. Press and hold the
button.
“12H” appears on the display.
3. Press the
button to switch
between “12H” and “24H”.
4. Press the
button to display
the clock in the selected mode.