A&D EJ-200 Scale User Manual


 
35
the unit weight.
Note: Pressing the PRINT key without adding
samples may reduce counting accuracy.
Starting from the 100 samples, 100 - may
be displayed when the sample weight is light.
This is for your notice and press the PRINT
key without adding any samples.
When aCai 0” (ACAI disabled) or “Umin 2” is
set, this notice is not shown.
CAL errors
Warning to indicate that calibration has been canceled
because the calibration weight is too heavy.
Warning to indicate that calibration has been canceled
because the calibration weight is too light.
Check the weighing pan and the calibration weight.
To return to the weighing mode, press the UNITS key.
Battery error
Warning to show that the batteries are exhausted.
Replace them with new one or use the AC adapter.
Warning to show that the battery voltage is too high.
Check the battery.
AC adapter error
Warning to show that the output voltage of an AC adapter
is too high. Check if the AC adapter is correct.
Warning to show that the output voltage of an AC adapter
is too low. Check if the AC adapter is correct.
Stability error
Warning to indicate that the weight value is not stable
and the balance cannot display it. Prevent vibration and
drafts. Press the UNITS key to return to the weighing
mode.
If you cannot cancel an error or other errors occurred, request service from the
store where you purchased the balance or from your local A&D dealer.
Cal e
-Cal e
lb0
error1
100 -
50 -
Hb1
lb1
Hb0