AC International AC1875PROHD Hair Dryer User Manual


 
IMPORTANT SAFEGUARDS
When using electrical appliances, especially when children are
present, basic safety precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS BEFORE USING.
KEEP AWAY FROM WATER.
DANGER: As with most electrical appliances, electrical parts
are electrically live even when the switch is in the
OFF position.
To reduce the risk of death by electrical shock:
1. Always “unplug” the appliance immediately after using.
2. Do not use while bathing.
3. Do not place or store appliance where it can fall or be pulled into
a tub or sink.
4. Do not place in or drop into water or any other liquid.
5. If appliance falls into water, “unplug it” immediately. Do not
reach into the water.
WARNING: TO REDUCE THE RISK OF BURNS, ELECTROCUTION. FIRE OR
INJURY TO PERSONS:
1. An appliance should never be left unattended when plugged in.
2. Close supervision is necessary when this appliance is used by, on,
or near children or invalids.
3. Use this appliance only for its intended use as described in this
manual. Do not use attachments not recommended by the
manufacturer.
4. Never operate this appliance if it has a damaged cord or plug, if it
is not working properly, or if it has been dropped or damaged, or
dropped into water. Call Consumer Service for examination and
repair. (See Warranty Section)
5. Keep the cord away from heated surfaces. Do not wrap the cord
around the appliance.
6. Never block the air openings of the appliance or place it on a soft
surface such as a bed or couch, where the air openings may be
blocked. Keep the air openings free of lint, hair, and the like.
7. Never use while sleeping.
8. Never drop or insert any object into any opening.
9. Do not use outdoors, or operate where aerosol (spray) products
are being used or where oxygen is being administered.
10.Do not direct hot air towards eyes or other heat sensitive areas.
11.Attachments may be hot during use. Allow them to cool before
handling.
1
AC1875PROHD_IB_13-2-03 2/13/03 12:35 PM Page 2