5 - 44
CHAS
HANDLEBAR
8. Install:
• Start switch 1
• Brake master cylinder 2
• Brake master cylinder bracket 3
• Bolt (brake master cylinder bracket) 4
• Clamp 5
OTE:
• The start switch and brake master cylinder
bracket should be installed according to the
dimensions shown.
• Install the bracket so that the arrow mark a
faces upward.
• First tighten the bolt on the upper side of the
brake master cylinder bracket, and then
tighten the bolt on the lower side.
T
R
.
.
9 Nm (0.9 m · kg, 6.5 ft · lb)
Zero mm
(Zero in)
Zero mm
(Zero in)
9. Install:
• Light switch 1
T
R
.
.
2 Nm (0.2 m · kg, 1.4 ft · lb)
10. Install:
• Engine stop switch 1
• Clutch lever holder 2
• Bolt (clutch lever holder) 3
• Hot starter lever holder 4
• Bolt (hot starter lever holder) 5
• Clamp 6
OTE:
• The engine stop switch, clutch lever holder
and clamp should be installed according to
the dimensions shown.
• Pass the engine stop switch lead in the mid-
dle of the clutch lever holder.
T
R
.
.
4 Nm (0.4 m · kg, 2.9 ft · lb)
T
R
.
.
4 Nm (0.4 m · kg, 2.9 ft · lb)
