12 DGX-630/YPG-635 Owner’s Manual
Setting Up
b Put the keyboard on the stand.
Check the back-to-front orientation for stand, and care-
fully place the keyboard on the side boards. Slowly move
the keyboard so that the holes on the bottom of the key-
board are properly aligned with the holes on the angle
brackets.
n Install the keyboard to the stand.
Fix the keyboard to the angle brackets, using the screws
y.
5–6
y 5 x 16 mm
roundhead
screws
■ Post-assembly checklist
Once you’ve assembled the stand, check the fol-
lowing points:
• Are there any parts left over?
➔ If so, read the assembly instructions again and correct
any errors you might have made.
• Is the instrument clear of doors and other movable
fixtures?
➔ If not, move the instrument to an appropriate location.
• Does the instrument make a rattling noise when you
play it or move it?
➔ If so, properly tighten all screws.
• Also, if the keyboard makes a creaking noise or
seems unsteady when you play it, refer carefully to
the assembly instructions and diagrams and
retighten all screws.
• Be careful not to drop the keyboard or to get your fingers caught
between the keyboard and the stand parts.
CAUTION
