5-30 Ethernet Setupbb ______________________________________
6. Select the General tab; then, click Print Test Page and check the
printer to see if the Windows NT Test Page printed correctly.
7. Click OK. The Printer Properties window closes.
8. Select File: Close. The Printers window closes.
After installing and configuring the AdobePS printer driver and PPD,
see “Configuring the Printer” in chapter 4 to verify that printer
interfaces are configured properly.
AppleTalk Setup for EtherTalk
After completing the AdobePS driver installation, use the following
procedure to configure your printer for Windows NT 4.X EtherTalk
printing.
1. Click Start: Settings: Printers. Then, right click on the new
XANTÉ icon and select Properties.
2. Click the Ports Tab; then, click Add Port. The Printer Ports
window appears (fig. 5.23).
3. Select AppleTalk Printing Devices; then, click New Port. A
window appears listing zone names if you have several
AppleTalk zones on your network. If no zone names appear,
skip to step 5.
Note: If AppleTalk Printing Devices is not an option, you
must log in as the Administrator and select Control
Panel: Network: Services and make sure that
Microsoft TCP/IP Printing is installed. If not, click
Add and select this feature. Then, restart your PC and
AppleTalk Printing Devices will appear as an option
for this procedure. (You may need the Microsoft NT
CD to load this service.)
4. Click on the desired zone name. A window appears listing
printers in that zone.
