A SERVICE OF

logo

Open as PDF
next previous
2006 Volvo V50
Checking the oil
1. Pull out the dipstick and wipe it with a lint-free rag.
2. Reinsert the dipstick, pull it out, and check the oil level.
3. Add oil if necessary. If the level is close to the MIN mark, add approximately 1 US quart (1 liter) of
oil.
4. Run the engine until it reaches normal operating temperature.
5. Switch off the engine and wait for at least 10-15 minutes and recheck the oil level. If necessary, add
oil until the level is near the Max mark.
CAUTION!
- Not checking the oil level regularly can result in serious engine damage if the oil level becomes too
low.
- Oil that is lower than the specified quality can damage the engine.
- Always add oil of the same type and viscosity as already used.
- Never fill oil above the MAX mark. This could cause an increase in oil consumption.
WARNING!
Do not allow oil to spill onto or come into contact with hot exhaust pipe
surfaces.
pg. 155 Fluids
file:///K|/ownersdocs/2006/2006_V50/06v50_10a.htm (7 of 14)12/30/2006 4:49:41 PM