FT-950
Operating Manual
Vertex Standard Co., Ltd.
9
Power Connection
The DC power connector for the FT-950 must only be connected to a DC source
providing 13.8 Volts DC (±10 %), and capable of at least 22 Amperes of current. Always
observe proper polarity when making DC connection:
The RED DC power lead connects to the Positive (+) DC terminal: and
The BLACK DC power lead connects to the Negative (–) DC terminal.
We recommend the use of the FP-1030A AC Power Supply. Other models of power
supplies may be used with the FT-950, but the 13.8 VDC input voltage, 22-Ampere
current capability, and DC cable polarity guidelines described above must be strictly
followed.
Note that other manufacturers may use the same type of DC power connections as does
your FT-950 transceiver, but the wiring configuration of the other manufacturer’s plug
may be different from the specified for your transceiver. Serious damage can be caused
if improper DC connections are made; consult with a qualified service technician when
in doubt.
Caution: Permanent damage can result improper supply voltage, or reverse-polarity
voltage, is applied to the FT-950. The Limited Warranty on this transceiver does not
cover damage caused by application of AC voltage, reverse polarity DC, or DC voltage
outside the specified range of 13.8 V ±10 %.
When replacing fuses, be certain to use a fuse of the proper rating. The FT-950 requires
a 25 A blade fuse.
Extending the Front Feet
In order to elevate the front panel for easy viewing, the front left and right feet of the
bottom case may be extended.
Pull the front legs outward from the bottom panel.
Rotate the legs counter-clockwise to lock them in the extended position. Be sure the
legs have locked securely in place, because the transceiver is quite heavy and an
unlocked leg could result in damage, should the transceiver move suddenly.
Retracting the Front Feet
Rotate the legs clockwise, and push them inward while rotating to the right.
The front feel should now be locked in the retracted position.
Adjusting the Main Tuning Dial Torque
