©2005 TRAC-RITE DOOR, INC.
Care must be taken that the door does not spin
around free as this may cause personal injury and/or
damage to the door. DO NOT grab the springs or
unbolt the springs while there is tension on the door
as this may cause personal injury.
CAUTION
BOTTOM OF
DOOR CURTAIN
WIND LOCK
WIND LOCK BAR
TAPCON
MASONRY FASTENER
WIND LOCK BAR
CONCRETE FILLED
BLOCK JAMB
DOOR CURTAIN
DOOR GUIDE
WIND LOCK
SETBACK
DIMENSION
3
8
" clearance
VIEW A-A
1
4
" for WOOD or STEEL
1
1
4
" for MASONRY
JAMB INTERIOR
DOOR GUIDE
JAMB OPENING
Figure 5.
Figure 4.
EDGE OF DOOR CURTAIN
INSIDE EDGE OF GUIDE
3
8
" CLEARANCE
Page 5
MAINTAIN
1
8
" TO
1
4
" GAP (3-6MM)
BETWEEN GUIDE & WEAR GUARD
MASONRY ANCHOR
MASONRY CLIP
TEK SCREWS
DOOR CURTAIN
BLOCK JAMB
DOOR GUIDE
NON-MASONRY
FASTENING HOLES
Figure 6.
Immediately install keepers and door stops. These
devices will prevent the door from rolling up and out
of the guides.
WARNING
DOOR CURTAIN
ROTATION DIRECTION
TOWARDS WALL
BANDS
(STRETCH WRAP &
CARDBOARD STRIPS)
W
A
L
L
DOOR STOP
WHIZ NUTS
TRACK BOLTS
Figure 7.
on to the door bottom assembly, carefully cut the steel bands
and feed the door curtain into the guides, moving the door
stops aside to let the bottom bar move past. Pull the door
bottom assembly down to waist level.
6.4 Fasten the tensioner and the axle saddle to the bracket
using 4 - 3/8-16 X 1” hex bolts.
7. GUIDE POSITIONING
7.1 Position the guides against the jambs according to the
clearance shown in Figure 4 (Figure 5 if windlock model).
Loosely fasten the guides to allow slight adjustment (guides
on doors 14’-10” and taller will have a splice). DO NOT
install the remaining fasteners until such time as the
adjustment is true. Level one guide and loosely install a
second fastener in the bottom hole. If mounting to masonry,
install clips provided as shown in Figure 6. Align the clips
with the holes along the length of the guide and flush with
the back of the guide. (Anchors by others).
8. PRE-TENSIONING & TOP STOP ASSEMBLY:
8.1 Install the track bolts, door stops and whiz nuts in each
side guide as shown in Figure 7. Do not tighten at this time.
8.2 Bend the guide tabs out slightly (about 1/4"). Standing
inside the opening looking out, place your hand on top of the
door and push away from you rotating the door nest (Figure
7). Rotate the door nest two complete revolutions. Hanging
