TL-WA750RE 150Mbps Universal WiFi Range Extender User Guide
z LED Explanation:
Name Status Indication
On
A secure connection has been established.
Flashing
TL-WA750RE is establishing a secure connection.
RE
Off
No connection is active.
Flashing
The wireless function of TL-WA750RE is enabled.
Wireless
Off
The wireless function of TL-WA750RE is disabled.
On TL-WA750RE is on.
Power
Off
TL-WA750RE is off.
On
A device is connected to the ETHERNET port, but there is no
activity.
Flashing
A device is connected to the ETHERNET port, and is active.
Ethernet
Off
No device is connected to the ETHERNET port.
On(1~5)
TL-WA750RE is connected to the router. More LEDs indicate a
better connection between TL-WA750RE and the router.
Flashing
TL-WA750RE is connected to the router, but isn’t connected to the
Internet.
Signal
Strength
Off TL-WA750RE isn't connected to the router.
Table 1-1
z
(RANGE EXTENDER/WPS): If your Wireless router or AP supports WPS or QSS
function, you can press the WPS or QSS button and then press the RANGE EXTENDER
button to establish a secure connection between the Wireless router (or AP) and the Range
Extender TL-WA750RE.
z RESET: This button is used to restore the Range Extender’s factory default settings.
There are two ways to reset the Range Extender’s factory defaults:
Method One: With the Range Extender powered on, use a pin to press and hold the RESET
button (about 8 seconds) until the System LED becomes quick-flash from slow-flash. And
then release the button and wait the Range Extender to reboot to its factory default settings.
Method Two: Restore the default settings from “System Tools > Factory Defaults” of the
Range Extender's Web-based management page.
z ETHERNET: One 10/100Mbps RJ45 Ethernet port used to add wireless connectivity to an
Ethernet-enabled device such as Internet TV, DVR, Gaming console and so on. Please note
that this port is not allowed to be connected with router or AP.
3
