LX DX TX CX
UNICYCLE ASSEMBLY
INSTRUCTION MANUAL
TorkerUSA.com
ASSEMBLING YOUR TX UNISTAR:
1. Determine the front, back,
right and left of the unicycle.
(**The sprocket is on the right.)
2. Take the axle nuts off the
wheel and install the Chain Ad-
justers [A]. Then thread the axle
bolts back on.
3. Slide the wheel into the drop
outs loosely [B] and set Chain
adjusters on to fork dropouts [C].
Do not fully tighten yet.
4. Place the chain around both
sprockets.
5. Now, tighten up the chain ad-
justers on each side using the
10mm wrench. Be sure to keep
the wheel centered inside fork.
NOTE: Check chain tension.
Chain may deflect 1/2” when
squeezed firmly.
7. Now, firmly tighten axle nuts.
8. Apply a small amount of grease
to the pedal threads. Thread the
pedals into their corresponding
crank arms [D-1=L-pedal to
L-crank. D-2=R-pedal to R-
crank]. Tighten securely w/ a
15mm wrench.
9. Slide QR seatclamp on top of
fork [K]. Apply a thin film of
grease to the seatpost and insert
seatpost/saddle into the fork [G].
Tighten the seatpost clamp with
your hand so that the seatpost
does not twist in the fork, and
lock-in.
10. Make sure the tire bead is
seated evenly on the rim. Inflate
the tire to the recommended
pressure that is printed on the
sidewall of the tire.
PARTS: Your TX Unicycle Box
should include all of the parts
listed on the DX,LX and CX - as
well as these additional pieces.
TOOLS: You will need the same
tools listed on the previous page
to assemble your Unistar TX.
Super
Long
TX
Chain
Wheel w/28t gear & tire
Chain Adjusters
TX
A] Attach chain
adjusters to axle.
B] Place wheel in
fork slots loosely.
C] Set Chain
Adjusters in to
dropouts, like so.
E] Put chain on.
I] Tighten chain
adjusters to pull
chain tight. Be
sure to keep wheel
centered (below).
J] Now tighten
axle nuts. Then,
attach correct
pedals on to
correct cranks
arms.
** Read directions for
specifics.
K] Slide on seat
clamp, insert seat
post and tighten.
TORKER BICYCLES / Seattle Bike Supply
7620 So 192nd, Kent, WA 98032
Have a question? E-mail: info@torkerusa.com
