6
STANDBY CONTROL
To turn the radio on:
Press the • MENU/ button on the front panel or the red
button on the remote control.
The display will light and the radio will switch on.
To turn the radio o:
Press and • hold the MENU/ button on the front panel or
press the button on the remote control briey.
The radio will switch o. The clock will continue to run whilst
mains power is connected.
INITIAL SCAN
When your radio is switched on for the rst time the
scanning display will be shown while the scanning process
takes place:
POWER CONTROL ADJUSTING THE VOLUME
To adjust the volume from the front panel controls:
Turn the • VOLUME/SELECT button to adjust the volume,
clockwise to increase and anti-clockwise to decrease.
To adjust the volume from the remote control:
Press the • or button to increase or decrease the
volume level.
When the volume is adjusted the display will change to show
the current volume setting on a bargraph.
The radio scans all usable stations (full scan) and stores them
alphanumerically - 1 Radio, 2 Radio, AA Radio, AB Radio...
The initial scan will take a few minutes. After the scan, the
clock will be set and the radio will display the name of the
rst station in the sequence. To select this station, push the
VOLUME/SELECT/ENTER control on the front panel (or the
SELECT/ENTER button on the remote control). To browse for
another station, refer to the next section.
Progress bar Number of stations found
BROWSING FOR A STATION
To browse for another DAB station from the front
panel controls:
Press the • MENU button.
<Station list> will be displayed.
Push the • VOLUME/SELECT control to display the station
list.
Turn the • VOLUME/SELECT control to browse the station
list.
Push the • VOLUME/SELECT control to select the station
displayed.
After a short delay, the radio will tune to the station.
To browse for another DAB station from the remote
control:
Press the • M or N button repeatedly to browse through
the station list.
When you nd a station you want to play, press the •
SELECT/ENTER button.
After a short delay, the radio will tune to the station.
Volume bargraph
MUTE
To mute the sound:
Press the • MUTE button.
The sound will mute and ‘Volume Muted’ will be displayed..
Press the • MUTE button again to restore the sound to its
previous volume level..
