A SERVICE OF

logo

Open as PDF
next previous
7
Operation
1. Dip Switches
On the bottom of the unit you will find 4 dip switches or four small white
switches. These switches are used to control the tone, the sound of the tone and
the calibration.
Up is on. Down is off.
Beep On SW1 Up
Beep Off SW1 Down
Continuous Tone SW2 Up
Beep Tone SW2 Down
Manual Calibration SW3 Up
SW4 Down
Self Calibration SW3 Down
SW4 Up
2. Adjusting Activation Distance
The maximum distance allowed for activation (“activation distance”) can be
adjusted from a few centimeters to less than a millimeter. This adjustment can
be made manually or automatically (self-calibration), as explained below. When
the activation distance is reduced to its minimal value, the switch simulates a
zero force touch switch. When activation distance of, say, four centimeters, is
chosen, the switch can be activated from as far away as four centimeters.