10
|
ENGLISH
OPERATING YOUR EVERYDAY FABRIC STEAMER
NOTE: Be sure that Water Tank has been lled and, if desired, the Fabric Brush is
connected before following these steps.
1. For rst-time use, remove protective plastic cover that is shipped on electrical plug. Plug
power cord into a convenient 3-prong electrical outlet (FIGURE 8-A).
CAUTION: This unit uses a grounded (3-prong) electrical plug. Use only in properly
installed 3-prong electrical outlets. Do not attempt to alter plug or circumvent this
safety feature in any way.
2. Set Lighted On/Off Switch to “ON” position (FIGURE 8-B), and verify that switch is illuminated.
3. After approximately 40 seconds of heating time, unit will begin producing a ow of steam from
Steam Nozzle.
NOTE: It is common for the unit to produce gurgling sounds and small amounts of water
during the rst few minutes of steaming. This is due to water condensation inside cold
Hose, and should be reduced as the Hose heats up. Pointing Steam Nozzle downward
and shaking it may help to remove excess water from Hose more quickly (FIGURE 8-C).
4. Once steam ow is steady and excess condensation has been removed from Hose, you may
proceed with your steaming tasks. Refer to Fabric Steaming section on Page 11 for more
information about steaming garments and other fabrics.
CAUTION: Always be sure that Steam Nozzle is pointed in a safe direction (away from
yourself, other people, pets and plants) when steaming.
5. When you are nished using the Everyday Fabric Steamer, immediately set Lighted On/Off
switch to “OFF” position and unplug power cord from electrical outlet. Refer to Storage & Care
on Page 12 for proper cleaning and storage procedures.
Using Your
Everyday Fabric Steamer
FIGURE 8
8-A 8-B 8-C
