Instruction Manual
13
Hotkey Commands for Remote Unit
The Video Adjustment function is on Remote Unit only. To launch its hotkey command,
also start with the specic leading code depending on situation, and then press F11 to
enter Video Adjustment Mode. After adjustment, just press Esc to escape from this Mode.
Hotkey Commands
Function Descriptions
Keyboard Push-Button
[E]
Video Adjustment
Equalizer / Gain Adjustment
Equalizer (Sharpness):
(Num Lock LED + Caps Lock LED) Flashing
1. For both 1st and 2nd monitors
1.1 Press or to coarse tune; 16 levels for adjustment
1.2 Press and Hold Shift + or to ne tune
2. For 1st Monitor
(Num Lock LED + Caps Lock LED) Flashing
2.1 Press F1 or F2 to coarse tune; 16 levels for adjustment
2.2 Press and Hold Shift + F1 or F2 to ne tune.
3. For 2nd Monitor
(Num Lock LED + Caps Lock LED) Flashing
3.1 Press F5 or F6 to coarse tune; 16 levels for adjustment
3.2 Press and Hold Shift + F5 or F6 to ne tune.
Gain (Brightness):
(Caps Lock LED + Scroll Lock LED) Flashing
1. For both 1st and 2nd monitors
1.1 Press or to coarse tune; 16 levels for adjustment
1.2 Press and Hold Shift + or to ne tune.
2. For 1st Monitor
(Num Lock LED + Caps Lock LED) Flashing
2.1 Press F3 or F4 to coarse tune; 16 levels for adjustment
2.2 Press and Hold Shift + or to ne tune
3. For 2nd Monitor
(Num Lock LED + Caps Lock LED) Flashing
3.1 Press F7 or F8 to coarse tune; 16 levels for adjustment
3.2 Press and Hold Shift + F7 or F8 to ne tune
