In the accessories bag you will also find a spanner that
is to be used for removing brackets and leveling
REMOVING SHIPPING BRACKETS
Remove back panel screws and lift panel clear
Remove fixing screws from the four
cross bearing (Fig. 2) then remove brackets.
Fix back panel with 3 screws previously removed
4 holes on the cabinet with the plastic
blanking plugs that you will find in the accessories
After selecting a permanent location, the machine
should be properly leveled to prevent vibration.
To do this, adjust one or b
oth front levelers, as needed,
after loosening the lock nuts. Once your washer is pe
fectly leveled, be sure to tighten the lock nuts (Fig. 4).
FOR YOUR OWN PROTECTION, AND TO PREVENT ACCIDENTS, INJURY AND FIRE, PLEASE READ
•
Destroy the carton and plastic bags after the washer
•
Children should never be left alone or unattended
area where appliances are located.
•
Washer installation and grounding must be done in
accordance with local codes by a qualified installer.
Installation instructions are included in this manual for
•
Use only low sudsing detergents suitable for front
ing washers, or a small amount of regular dete
gent. The soap suds should never exceed the mid
•
The washer must be plugged into a properly grounded
three (3) prong electrical outlet. For your safety, the
third or round grounding prong must never be removed.
•
Repair or replacement of a part should be made only by
a qualified service technician to prevent personal injury
or damage to the machine. Ask your dealer for a list of
•
Disconnect power to the washer at the circuit breaker or
fuse box, or unplug the machine in an emergency, or
when servicing is required. Have the installer show you
r switch or fuse at the electrical
The Appliance Should Be Connected To
An Individual Branch Circui
And Protected By 15 A Fuse or Breaker.
