Before using the washer for the first time, wipe the inside
and outside with a damp cloth to remove any travel d
that has accumulated and we recommend operating a rinse
cycle to rinse out your machine.
Be sure the hot and cold water fauc
Make sure that the power cord is plugged in and that the
a load of convenience we suggest
machine may be set to wash and dry autom
size sets will dry quicker and king
longer. Different types of materials may benefit from
being shaken out once the dry cycle has run long enough
(approximately 2 minutes) to allow the door to be opened.
nt the clothes are able to tumble freely to
allow the drying process to occur. Dry times of over 100
load condition that has resulted
in a loss of dry performance.
•
Use only 1 to 2 tablespoons of powder detergen
liquid equivalent. For cold/cold wash and rinse add
detergent to dispenser "A"; for all other wash cycles,
to dispenser "B". Refer to Wash Table for
•
Set the wash timer to regular wash. Set the water
selector to the desired wash rinse temperatures.
•
Set the heat and spin buttons to the out positions.
•
WDC1024M) (This automatically includes a 12 minute
•
•
•
Water will begin to enter the drum and the wash cycle
will start. Wash time will be approximately 60 minutes,
upon completion, the machine will automatically start
When the dryer has completely finished
it's cycle the machine will automatically stop.
•
After washing and drying are complete the hot and cold
water faucets should be turned off and push the ON/
OFF switch. Wipe the inside off the washer door and
cloth or sponge to remove any
•
Once the machine is started in the wash cycle, for your
safety, the door is automatically locked and cannot be
opened. Attempting to open the door may break the
dle or the latch. If for some reason the door must be
opened during the cycle, operate in the following way:
•
•
Turn timer knob to spin position.
•
Press push button ON and wait until water is
•
OFF and wait at least 2 minutes for
•
To restart go back to "Operating Steps".
obtain a better wash. It will disperse any superficial dirt
and help loosen soil ready fo
wash, select the main wash cycle you wish to use.
Then turn the timer knob to the pre
immediately preceding the regular cycle. If pre
detergent is required, the detergent must also be added in
tment "A" of detergent dispenser. After the
wash is completed the machine will automatically
When you set a combined program of washing
drying, the cylinder must not be loaded with
red load size stated earlier in this
Judge this load by the dry times achieved. Dry times of
e an overload condition that has
resulted in a loss of dry performance.
