TV menu system
29
Further Programme Preset menu
(for analogue channels only)
To check which mode you are in, press the button on the remote control. If you are
watching a digital programme, an Info display appears on screen providing brief details
for the current and next programme. If this happens, press the DIGITAL/ button on
the remote control to switch to analogue channels.
The ‘Further Programme Preset’ option in the ‘Manual Set Up’ menu allows you to
obtain a better picture if there is interference, set the volume level of an individual
channel, fine tune the TV and set up a channel for viewing signals from a Decoder. With
the ‘Further Programme Preset’ option highlighted, press b to enter the ‘Further
Programme Preset’ menu. Press v or V to highlight the channel number you require.
Press b repeatedly to select one of the following options:
(a) ATT (RF Attenuator). This allows you to improve the picture if there is interference
from other channels. Press v to select On. Press OK to store.
(b) VOL (Volume Level Offset). This allows you to set the volume level for an
individual channel. Press v or V to adjust the volume level over a range of -7 to
+7. Press OK to store.
(c) AFT (Automatic Fine Tune). This allows you to fine tune a channel. Press v or V
to select On. Alternatively, press v or V to manually adjust the tuning frequency
over a range of -15 to +15. Press OK to store.
(d) DECODER. This allows you to set a channel for viewing scrambled signals (e.g.
from a pay TV decoder). Press v or V to select AV1 or AV3 depending on which
socket the equipment is connected to. Press OK to store. The unscrambled signal
now appears on the selected channel.
NX 24-33.fm Page 29 Monday, September 16, 2002 2:04 PM
