Getting Started
13
Connecting the VCR
Connection to your TV and Set-Top Box (STB)
If you don’t use a STB, skip to page 16.
The illustration below shows an example of connecting the STB to LINE-3 IN.
You can watch programmes from the Set-Top Box connected to this VCR on your TV
even when the VCR is turned off using the Line Through function. When you turn on
the STB, this VCR automatically sends the signal from the STB to the TV without
turning itself on
Note
• You cannot watch programmes from your STB on the TV while recording unless you record
a programme from your STB.
1
Connect the STB to the DECODER/LINE-3IN connector as shown above.
2
Set DECODER/LINE-3 to LINE-3 in the OTHER OPTIONS menu.
3
Set POWER SAVE to OFF in the OTHER OPTIONS menu.
4
Turn off the VCR.
To watch a programme from the STB, turn on the STB and your TV.
:Signal flow
t
LINE-3 IN
AERIAL
IN
i
LINE-1
(TV)
Aerial cable (supplied)
AERIAL
OUT
Scart cable (supplied with Set-
Top Box)
Scart
(EURO-AV)
Set-Top
Box
Scart
(EURO-AV)
Scart cable (not supplied)
continued
