Quick Start Guide
4-206-495-01
Thank you for purchasing this
Sony Trinitron Digital Television.
Insert batteries into the remote control.
Connect the aerial to your TV.
Connect a video cassette recorder (VCR) to
your TV.
Tune your TV.
View TV programmes.
1
Checking the supplied
accessories
Batteries
The following accessories are included with your TV.
RF Loopthrough cable
Inserting batteries into
the remote control
Connecting the TV
After following this step by step guide you will be
able to:
3
2
Insert the batteries as shown below.
KD-32DX100U
Remote Control
Always remember to:
• observe the correct polarity when inserting batteries,
• dispose of batteries in an environmentally friendly way.
1 Connect your existing aerial lead to the Digital socket marked on the rear of
the TV as shown.
2 Connect the supplied RF loopthrough cable from the sockets marked to the
Analogue socket marked .
1 Connect your existing aerial lead to the Digital socket marked on the rear of
the TV as shown.
2 Connect the supplied RF loopthrough cable from the aerial socket marked
on the TV to the RF input socket of your VCR.
3 Connect an RF lead from the RF output of your VCR to the Analogue TV socket
marked .
4 Connect a scart lead from the scart socket marked on the rear of the
TV to a scart socket on your VCR (Refer to the VCR instructions).
5 Connect the VCR to the mains socket and switch on.
6 Insert a pre-recorded tape into the VCR and press the ‘PLAY’ button. This
enables the TV set to locate and store the video channel during the
‘Automatically tuning the TV’ procedure.
3/
s
3
Existing aerial lead
RF Loopthrough
cable (supplied)
Connecting an aerial only
Scart lead
(not supplied)
Rear of VCR
RF Loopthrough
cable (supplied)
RF Lead
(not supplied)
Connecting an aerial and a VCR
Existing aerial lead
1 2 3
