4
GB
Setting Up
Attaching the Table-Top
Stand (except KDL-
60LX903)
1 Refer to the supplied Table-Top Stand
leaflet for proper attachment for some
TV models.
2 Place the TV set on the Table-Top
Stand.
3 Fix the TV to the Table-Top Stand
according to the arrow marks that
guide the screw holes using the
supplied screws.
~
• If using an electric screwdriver, set the tightening
torque at approximately 1.5 N·m {15 kgf·cm}.
4 After all the screws have been
tightened, attach the supplied stand rear
cover to the Table-Top Stand.
Adjusting the viewing angle of
the TV (except KDL-60LX903)
This TV can be adjusted within the angles
shown below.
~
• To return to 0°, reverse the above procedure.
1
4
2
3
Remove screw as
shown.
6º0º
Install screw into
the top screw hole
of the Table-Top
Stand.
Slide in.Lift up and tilt.
