14
Running initial setup
1 Complete your cable connections
before proceeding with the Initial
Setup.
Connect the TV to your nearest power
outlet.
2 Check the ENERGY SAVING
SWITCH setting is on (z).
3 Press POWER on the TV.
When you switch the TV on for the first
time, the Language menu appears on
the screen.
4 Follow the instructions on the screen.
~
• The ENERGY SAVING SWITCH must be
on (z) to set the clock and obtain program
information for the TV Guide.
• Home mode sets the TV to settings optimized for
home viewing (this setting is ENERGY STAR
compliant).
5 Select Continue to scan for available
channels and enable the
TV Guide On
Screen
®
feature. If you receive channels
from a cable box or satellite receiver
and do not wish to use the TV’s built-in
tuner, select
Skip.
Selecting
Skip will disable the TV Guide
On Screen
feature, which is only
available when the TV’s tuner is used.
~
• If you skip the channel scan while in the setup
menus, TV Guide will be disabled.
Detaching the Table-Top
Stand from the TV
Remove only the screws marked with on
the TV.
~
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• For XBR-52/46HX909 and KDL-40HX800,
remove the stand rear cover prior to detaching the
Table-Top Stand.
• For KDL-55HX800, when installing the TV on a
wall, remove the four screws from the rear of the
TV. (They are fastened in the screw holes for wall
mounting.) Be sure to store the removed screws in
a safe place, keeping them away from children.
• For KDL-55HX800, when attaching the Table-
Top Stand again, be sure to fasten the four screws
(previously removed) to the original holes on the
rear of the TV.
• Do not hold by the stand rear cover while carrying
the Table-Top Stand to prevent dropping the stand
which may cause an injury or damage to the
property.
POWER
