38
Setup
Satellite Receiver
and VCR
To connect a satellite receiver and VCR
1 Connect the CATV cable to the single (input) jack of the splitter.
2 Use the 75-ohm coaxial cable to connect one of the splitter’s two output
jacks to the TV’s CABLE jack.
3 Use the 75-ohm coaxial cable to connect the splitter’s other output jack
to the satellite receiver’s VHF/UHF input jack.
4 Connect the satellite antenna cable to the satellite receiver’s satellite
input jack.
5 Use the 75-ohm coaxial cable to connect the satellite receiver’s
VHF/UHF output jack to the VCR’s VHF/UHF input jack.
6 Use an A/V cable to connect the satellite receiver’s A/V output jacks to
the TV’s A/V input jacks (VIDEO 1 or 3).
7 Use an A/V cable to connect the VCR’s A/V output jacks to the TV’s
A/V input jacks (VIDEO 1 or 3).
8 Run Auto Program, as described in “Setting Up the Channel List” on
page 53.
Using S VIDEO jacks? See page 29.
