69
Customizing Your Camcorder
GENERAL SET
(Other setup items)
Touch 1, then 2.
If the item is not on the screen, touch v/V
to change the page.
How to set
(HOME MENU) t page 57
(OPTION MENU) t page 70
The default settings are marked with B.
The default setting is [ON], allowing you to
view the demonstration in about 10
minutes, after you slide the POWER switch
to (Movie).
z Tips
• The demonstration will be suspended in
situations such as those described below.
– When you press START/STOP or PHOTO.
– When you touch the screen during the
demonstration (The demonstration starts
again after about 10 minutes).
– When you remove or insert a “Memory Stick
PRO Duo.”
– When you set the POWER switch to
(Still).
– When you press (HOME), (VIEW
IMAGES), or (Film Roll Index).
The camera recording lamp on the front of
your camcorder lights up, as the default
setting is [ON].
See page 94.
DEMO MODE
REC LAMP (Recording
lamp)
CALIBRATION
B5 min
The camcorder is automatically turned off
when you do not operate your camcorder
for more than approximately 5 minutes.
NEVER
The camcorder is not automatically turned
off.
b Notes
• When you connect your camcorder to a wall
socket, [A.SHUT OFF] is automatically set to
[NEVER].
The default setting is [ON], allowing you to
use the supplied Remote Commander
(p. 102).
z Tips
• Set to [OFF] to prevent your camcorder from
responding to a command sent by another VCR
remote control unit.
A.SHUT OFF (Auto shut
off)
REMOTE CTRL (Remote
control)
