62
GB
To set the ID of the surround
amplifier
Refer to the operating instructions of the
surround amplifier.
To set the ID of the S-AIR
receiver
Refer to the operating instructions of the S-AIR
receiver.
You can receive the system’s sound by the
S-AIR receiver while the main unit is in standby
mode by setting “S-AIR STBY” to “STBY ON.”
1 Press SYSTEM MENU.
2 Press X/x to select “S-AIR STBY,” then
press or c.
The selected item appears in the front panel
display.
3 Press X/x to select the desired setting,
then press .
• “STBY ON”: You can receive the
system’s sound by the S-AIR receiver
while the unit is in standby mode or turned
on.
• “STBY OFF”
: You cannot receive the
system’s sound by the S-AIR receiver
while the unit is in standby mode.
4 Press SYSTEM MENU.
Note
• When you turn the system off while “S-AIR STBY”
is set to “STBY ON,” “S-AIR” flashes (when
wireless transmission between the unit and S-AIR
receiver is not activated), or lights up (when wireless
transmission between the unit and S-AIR receiver is
activated) in the front panel display.
When using S-AIR products, neighbors may
also receive your system’s sound if IDs are the
same, or you may receive sound from neighbors.
To prevent this, you can identify the unit with a
specific S-AIR sub unit by performing the
pairing operation.
When you perform pairing, wireless
transmission is activated between the paired
main unit and S-AIR sub unit only.
1 Place the S-AIR sub unit that you want
to pair near the unit.
2 Match the IDs of the unit and the S-AIR
sub unit.
• To set the ID of the unit, see “To set the ID
of the unit” (page 61).
• To set the ID of the surround amplifier,
refer to the operating instructions of the
surround amplifier.
• To set the ID of the S-AIR receiver, refer
to the operating instructions of the S-AIR
receiver.
3 Press SYSTEM MENU.
4 Press X/x to select “PAIRING,” then
press or c.
The selected item appears in the front panel
display.
5 After “START” appears in the front
panel display, press .
The unit starts pairing and “SEARCH”
flashes in the front panel display.
To cancel pairing, press SYSTEM MENU.
6 Start pairing of the S-AIR sub unit.
x For the surround amplifier
Press "/1 on the surround amplifier to turn
on the surround amplifier and press
PAIRING on the rear panel of the surround
amplifier. (To press PAIRING, a slim
Enjoying sound by the S-AIR
receiver while the main unit is
in standby mode
For the S-AIR receiver
Identifying the unit with a
specific S-AIR sub unit
(Pairing operation)
For the surround amplifier
For the S-AIR receiver
