1
1. Installing the DVD-ROM Drive
Before you begin, turn off the system power. Follow the steps below to install the DVD-
ROM drive:
1. Remove the cover from your system. Refer to your system user’s guide.
2. Adjust the Master/Slave jumpers on the back of the DVD-ROM drive as necessary.
(The factory default is Master. Please refer to Section 4 for more information.)
3. Insert the DVD-ROM drive unit into a free 5.25-inch drive bay. Secure the DVD-ROM
drive to the drive bay rails with the mounting screws included in the DVD-ROM
package. Refer to your system manual for instructions on how to install a drive.
4. Plug a free power connector inside your PC into the Power socket on the back of the
DVD-ROM drive.
5. Plug a free IDE connector inside your PC into the drive’s IDE interface socket.
1. Digital Audio 5. Red Strip
2. Audio Cable 6. Power Cable
3. Red Strip 7. Self test for Factory only
4. IDE Cable
NOTE: The red edge of the IDE cable corresponds to pin 1 of the IDE interface on the
DVD-ROM drive.
6. Replace the cover and turn on the power.
NOTE
: Using the wrong type of cable with this product can cause it to malfunction.
Follow the instructions when connecting the product.
E
