Dubbing/Editing
64
Recording pictures
from a VCR
(DCR-PC107E)
You can record and edit pictures from a VCR
on a tape inserted in your camcorder via an
i.LINK cable.
Insert a cassette for recording in your
camcorder.
1 Connect your VCR to your camcorder
(p. 62).
2 Slide the POWER switch repeatedly to
select the PLAY/EDIT mode.
3 Set your camcorder to recording pause
mode.
1 Touch and select [PAGE3].
2 Touch [REC CTRL].
3 Touch [REC PAUSE].
4 Start playing the cassette on your
VCR.
The picture played on the connected device
appears on the LCD screen of your
camcorder.
5 Touch [REC START] at the point you
want to start recording.
6 Touch (stop) to stop recording.
7 Touch [ RET.], then .
z Tip
• appears when you connect your camcorder
and other devices.
Dubbing selected
scenes from a tape
– Digital program editing
You can select up to 20 scenes (programs)
and record them in the desired order to other
recording device such as VCRs.
Step 1: Preparing your camcorder
and VCR for operation
Follow the steps below when you are
performing Digital program editing for the
first time to a tape in a VCR. You can skip
this setting if you have set up the VCR by the
following procedure before.
b Notes
• You cannot perform Digital program editing on a
VCR that does not support [IR SETUP] codes.
• The operating signal for Digital program editing
cannot be transferred via the LANC jack.
• When your camcorder is connected to the VCR via
the DV Interface, you cannot record the title,
indicators, information for the Cassette Memory.
1 Connect your VCR to the camcorder
as a recording device (p. 62).
You can use either the A/V connecting
cable or the i.LINK cable to make the
connection. The dubbing procedure is
easier with the i.LINK connection.
2 Prepare your VCR.
Change the order
Results of editing
Delete unwanted scene
