A SERVICE OF

logo

FSD-800 User's Manual 7
100V~240VAC
50~60Hz
Figure 2. Rear Panel of FSD-800
Hardware Installation
1. Place the Switch on a smooth surface
2. Connect the output cord of power supply to the AC-jack.
3. Connect hub or PC to one port of the Switch using Category
3/4/5 UTP/STP cabling.
4. Connect another hub or PC to the other port of Switch by
following the same process as described in Step 3.
Notice:
Cable distance for FSD-800
The cable distance between the Switch and hub/PC should
not exceed 100 meter.
Make sure the wiring is correct
It can be used Category 3/4/5 cable in 10Mbps operation.
To reliably operate your network at 100Mbps, you must
use an Unshielded Twisted-Pair (UTP) Category 5 cable, or
better Data Grade cabling. While a Category 3 or 4 cable