HOW TO SET-UPYOUR MOWER(CONT'D)
TO ADJUST HEIGHT OF CUT (CONT'D)
CAUTION: DO NOT change the height of cut with
the engine running°
1_ The wheel adjusters give you five (5) different
cutting positions, Medium cut is the best for
most lawns.
2, High cut is approximately 3 5/8", medium cut
is approximately 2 1/2", and low cut is approx-
imately 1 3/8"o There are two (2) other post.
tions_ Pick the position which suits you for best
cutting (See Fig. 6),
3. The wheel adjusters on your lawn mower can
be easily adjusted as shawn in Fig, 7_ To
change the height of cut, squeeze adjuster
lever toward the wheel, moving up or do_ n
to selected height. Be sure all wheels are in
the same setting (See Fig, _)
4, When cutting in heavy or mni_l grass, the re_
of the lawn mower may be raised one setting
higher to allow better discharge of the grass.
REAR DEFLECTOR
The rear deflector, attached between the rear
wheels of your lawn mower, was assembled at
the factory and requires no assembly.
TO ASSEMBLE GRASS CATCHER
NOTE: The grass catcher for your mower is sup_
plied unassembled. To assemble your grass cat-
cher follow steps below,
1. Position clamp onto catcher frame as shown in
(Fig, 8) and close ends of clamp°
2_ Put grass catcher frame into catcher top (See
Fig. 8).
3, Put one (1) #10-24 x 5/8 truss head screw into
hole in catcher top and clamp and #10-24 lock-
nuts, DO NOT TIGHTEN (See Fig_ 8).
4, Put three (3) #10-24 x 5/8 truss head screws
into the catcher frame using #10.24 Iocknuts_
Use a flat blade screwdriver to drive screws
while holding the Iocknuts with adjustable or
3/8" wrench (See Figr 8).
5. Position baffle inside of catcher top as shown
in (Fig. 9). Put two (2) #10-24 truss head screws
into holes with two (2) #10-24 Iocknuts. Use a
flat blade screwdriver to drive screws while
holding the Iocknuts with adjustable or 3/8"
wrench.
6. Position top half of catcher on the bottom half
(See Fig, 8)°
7, Align the holes in sides of top and bottom
halves of catcher,
8. Install the eight (8) 1/4-20 x 5/8" truss head
screws with the eight (8) 1/4-20 "Keps" nuts
into the holes in the catcher side.
9_ Tighten the screws with a flat blade screw-
driver.
10_ Hold,the "Keps" nuts wdh" an adjustable or
7/16 wrench while tightening the screws.
NOTE: Be sure all screws and nuts are tight.
RIGHT
WAY
FIG, 5
_jl WHEEL ADJUS1E2 LEVER
SHOWN WITH WHEEL REMOVED
FIG. 6
FIG 7
TRUSS HEAD bCREW_ _ "
CATCHER TOP
FIG fl
